Step one: Remove the stapler/stacker
NOTE:
If the product does not have a stapler/stacker installed and you are installing an optional stapler/
stacker, go to
Step three: Install the optional or replacement stapler/stacker accessory on page 42
.
40
Chapter 2 Install and configure the finishing accessories
ENWW
1.
Turn off the product, and then disconnect the power cord.
CAUTION:
Turn the product off, wait five seconds, and then remove the power cord before attempting
to service the product.
2.
At the back of the product, disconnect the finishing accessory interface cable.
3.
Open the finishing accessory front cover. Release and hold the bottom handle first, and then release
and hold the top handle. Hold both handles at the same time, and then slide the finishing accessory
away from the product.
CAUTION:
Failure to follow these instructions might damage the product.
4.
Completely remove the finishing accessory.
ENWW
Install or replace a stapler/stacker or stapler/stacker with hole punch accessory for the HP LaserJet
Enterprise M806 and HP LaserJet Enterprise flow MFP M830
41