Step two: Unpack the optional or replacement booklet maker accessory
Unpack the booklet maker from the packaging.
Remove all tape and packing material from outside the accessory. Open all doors and remove all
tape and packing material from inside the accessory.
For recycling information, go to
HP recommends responsible disposal of the defective booklet maker.
Remove all of the shipping tape from the outside of the accessory.
Chapter 2 Install and configure the finishing accessories
Open the front door of the accessory, and then remove all of the shipping tape and packing materials
from inside the accessory.
Close the front door.
Make sure that you remove all of the shipping material from inside the accessory.
Remove all the shipping tape and packing materials from the output trays (callout 1) and the booklet
output tray (callout 2).
If installing an optional booklet maker, remove the intermediate paper transport unit (IPTU) and the
binder cover from the packaging.
If you are replacing an existing booklet maker, these parts are already installed on the product
and replacement of them is not required.
Install or replace the booklet maker or booklet maker hole punch accessory for the HP Color LaserJet
Enterprise M855 and HP Color LaserJet Enterprise flow MFP M880